Intro
AIMTDR 2021 Conference Core Organizing Committee
Foreword
Contents
About the Editors
Prediction of Machining Quality and Tool Wear in Micro-Turning Machine Using Machine Learning Models
1 Introduction
2 Experimental Study
2.1 Speed Control
2.2 Cutting Tool
2.3 Vibration Measurement
2.4 Surface Roughness Measurement
2.5 Tool Flank Wear Measurement
3 Machine Learning Models
3.1 Multilayer Perceptron
3.2 Random Forest (RF)
3.3 Regression Trees
3.4 Radial-Based Functions (RBF)
4 Results and Discussion
5 Conclusions
References

Plasma Characterization in Ultrasonic Vibration-Assisted Micro-Electrical Discharge Machining (µ-EDM)
1 Introduction
2 Ultrasonic Vibration-Assisted EDM
3 Experiment Performed
4 Plasma Temperature and Density
4.1 Analysis of the Spectrum
4.2 Calculation of Plasma Temperature
4.3 Electron Density Calculation
5 Results and Discussions
5.1 Plasma Temperature
5.2 Electron Density
5.3 Effect of Ultrasonic Vibration
6 Conclusions
References
Effect of Process Parameters on Accuracy of Holes Drilled on Quartz by Micro-USM
1 Introduction

2 Experimental Setup Details and Planning
3 Measurement of Responses
3.1 Measurement of Overcut
3.2 Measurement of Taper Angle
4 Results and Discussion
4.1 Variation of Overcut with Process Parameters
4.2 Variation of Taper Angle with Process Parameters
5 Conclusions
References
Influence of Vibration in the Nozzle Frame on the Ribbon Characterization in Planar Flow Melt Spinning Process
1 Introduction
2 Experimental
3 Results and Discussion
4 Conclusion
References

Experimental Investigation into Wire Electrochemical Micro-Machining for Reduction of MicroSparks and Overcut
1 Introduction
2 Experimental Setup
3 Experimental Planning
4 Results and Discussion
4.1 Influence of Feed Rate on MicroSpark and Overcut
4.2 Influence of Machining Voltage on MicroSpark and Overcut
4.3 Influence of Voltage Pulse Frequency on MicroSpark and Overcut
4.4 Influence of PZT Tool Vibration Frequency on a Micro Spark
4.5 Influence of PZT Vibration Amplitude on Micro-Sparks
5 Controlled Parametric Micro-Slit Fabrication
6 Conclusions
References

Influence of Voltage Pulse on Machining Accuracy in Electrochemical Micromachining
1 Introduction
2 Influence of Voltage Pulse on Machining Accuracy
2.1 Control of Micro-Tool Feed Rate
3 Experimental EMM SetUp
4 Experimental Planning
5 Experimental Result Analysis
6 Conclusions
References
A Study on the Influence of Cutting Tool Geometry on the Temperature of the Workpiece in Nanometric Cutting of Silicon
1 Introduction
2 MD Simulation
3 Modeling
4 Results and Discussion
4.1 Analysis of Temperature During Machining