Intro
AIMTDR 2021, Conference Core Organizing Committee
Foreword
Preface
Contents
About the Editors
Forming
A Novel Method for Identification of Mechanical Properties During Impact Forming of SS 304L Sheet
1 Introduction
2 Experimental Methodology
2.1 Mechanical Properties of the Material
2.2 Shock Tube Experiment
2.3 Strain Rate Evolution Measurement
3 Results and Discussion
3.1 Determination of Rate-Dependent Mechanical Properties
4 Conclusions
References
An Experimental Study of Forced Cooling in Single-Scan Laser Bending
1 Introduction

2 Experimental Details
3 Results and Discussion
4 Conclusion
References
Determination of the Flow Stress of Material Based on a Friction-Independent Test on a Simple Geometry
1 Introduction
2 Proposed Method for Determining the Flow Stress
2.1 Optimization Procedure
2.2 Details of Experiment
3 Results and Discussions
4 Conclusions
References
Development of Flexible Mechanism for Two-Point Incremental Forming
1 Introduction
2 Challenges in ISF
3 Fixture Design
4 Development of Design
5 Results and Discussion
6 Conclusion
References

Effects of Multi-axis Forging on Mechanical and Microstructural Properties of AA6061-T6 Aluminum Alloy
1 Introduction
2 Experimental Procedure
3 Results and Discussion
3.1 Compression Test
3.2 Microstructural Study
3.3 Hardness Study
3.4 Approximate Flow Curves
3.5 Wear Study
4 Conclusion
References
Experimental Investigation of Multi-stage Robot-Assisted Single Point Incremental Sheet Forming of Al 6061 Sheet
1 Introduction
2 Experimental Setup
3 Experimental Parameters
4 Results and Discussion
5 Conclusion
References

Finite Element Prediction of Deep Drawability of Tailor-Welded Blanks Using Non-associated Flow Rule and Anisotropy of Sheet Metal
1 Introduction
2 Experiments
2.1 Material Selection
2.2 Fabrication of Tailor-Welded Blanks
2.3 Deep Drawing
3 Material Modeling Using Non-associative Flow Rule
4 Finite Element Modeling
5 Results and Discussion
5.1 Parameter Identification for the Combined Hardening Model
5.2 Prediction of Thinning Profile
5.3 Effect of Non-uniform Material Flow on the Cup Edge Profile
5.4 Weld Line Movement
6 Conclusions
References

Investigation on Single-Point Incremental Forming Process of SS316 Sheets at Elevated Temperatures
1 Introduction
2 Geometry Selection and Feasibility Analysis
3 Experimental Setup
3.1 Experimental Strategy
3.2 Forming of Parts
4 Results and Discussion
4.1 Forming Limit Diagram
4.2 Depth of Failure
4.3 Thickness Distribution
4.4 Microstructural Study
5 Conclusion
References
Numerical and Experimental Study on Hydroforming of Thin Metallic Sheets
1 Introduction
2 Tooling and Experiment
2.1 Design of the Die
2.2 Fabrication of Die