Intro
Organizing Committee
Preface
Contents
Manufacturing Process
Development and Design of IoT-Based Poultry Weighing Tools
1 Introduction
2 Methodology
3 Result and Discussion
4 Conclusion
References
Effect of Machining Parameters on Surface Quality of Aluminium Puncher for Microchannel Fabrication Using Micro Cutting Process
1 Introduction
2 Experiment
2.1 Design of Experiment (DOE)
2.2 Microchannel Machining
2.3 Surface Roughness Measurement
3 Discussion
4 Conclusion
References

Wear Behaviour of Tungsten Carbide in End Milling Process of Aluminium Alloy 6061-T6 with Minimal Quantity of Tri-hybrid Nanofluids
1 Introduction
2 Methodology
3 Wear Mechanisms
3.1 Attrition and Micro-attrition
3.2 Flaking and Micro-flaking
3.3 Flank Wear
3.4 Coating Delamination
3.5 Abrasion and Micro-abrasion
3.6 Thermal Crack
4 Conclusion
References
Experimental and Simulation Approach
Investigation Effect of Axial Feed Rate to the Cutting Force in Dimple Milling Using Ball End Mill Tool
1 Introduction
2 Methodology
2.1 Experiment Setup

2.2 Finite Element Analysis
2.3 Pre-processing
2.4 Post Processing
3 Result and Discussion
3.1 Experiment Results
3.2 Simulation Results
4 Conclusion
References
Assembly Sequence Optimization to Minimize Reorientation and Tool Changes Using Genetic Algorithm
1 Introduction
2 Literature Research
3 Model and Case Study
4 Results and Discussion
References
Surface Roughness Analysis on Sheet Metals During AWJ Machining Using Low Pressure
1 Introduction
2 Methodology
3 Result and Discussion
4 Conclusion
References
Manufacturing System

Design of Intervention for Operator in the Inspection Department of PT. XY Using Pahl and Beitz Method
1 Introduction
2 Research Methodology
3 Results and Discussion
3.1 Problem Identification
3.2 Planning Phase and Task Explanation
3.3 Product Concept Design Stage
3.4 Product Design Stage
3.5 Product Detail Design Stage
3.6 Product Design Validation
3.7 Implementation Result Assessment
4 Conclusion
References
Supply Chain Network Design for e-Groceries Using Clustering and Linear Programming
1 Introduction
2 Modeling
2.1 Linear Programming Models

2.2 Customer Clustering
3 Numerical Experiments
3.1 Parameters
3.2 Results
4 Conclusions
References
A Closed-Loop Supply Chain Inventory Model with Remanufacturing and Cleaner Production System
1 Introduction
2 Notations and Assumptions
3 Model Formulation
4 Solution Method
5 Numerical Example and Analysis
6 Conclusions
References
Analysis of Cardboard Sheets Supplier Selection Using Fuzzy AHP and TOPSIS Methods at PT. XYZ
1 Introduction
2 Research Methodology
2.1 Data Collection Method
2.2 Data Processing Method